J-3 CubAft Bulkhead
Stringers and Center Section
I really meant to go out to the North Beech field
this morning to watch the guys fly rubber powered FAC models at 0730, but I
slept in instead. I felt a little burned out on modeling this morning, but I
kept working on the J-3 Cub off and on most of the day. I had a heck of
time getting the stringers on the aft bulkheads to line up smoothly. I had
to keep modifying the notches until I finally got them installed. I also
spent quite a bit of time putting in the additional center section
structural members, but finally got most of that completed as shown below.
Here is a close up of what I accomplished today.
It doesn't look like much to show for a day's work, but then remember, I
work pretty slow.
I think I will take a little break from the J-3
Cub tomorrow, just get my head clear.....................Tandy